How to Set Cycle Seat (Saddle) Height and Measure Inside Leg
To set cycle seat height: sit on the saddle with your heel on the pedal at the bottom of the stroke — your leg should be straight. When you pedal normally with the ball of the foot, the knee will then have a slight bend. For beginners and children, set it lower so both feet can touch the ground. Measure inside leg (floor to crotch, in socks) to choose a frame size.
- Heel on pedal = straight leg
- Ball of foot = slight bend
- Kids: lower, feet reach ground
- Inside leg sets frame size
Wondering how to set cycle seat height? It's the single most useful adjustment on any cycle. Too low and pedalling is tiring; too high and you rock in the saddle and strain your knees.
The heel method (adults)
- Loosen the seat post clamp.
- Sit on the saddle, holding a wall for balance.
- Pedal backwards to the bottom; put your heel on the pedal.
- Adjust until your leg is straight in that position.
- Make sure the minimum insertion line on the seat post stays inside the frame.
- Tighten and test ride — pedalling with the ball of your foot, the knee is slightly bent.
Children and beginners
Set the saddle lower so the balls of both feet (or flat feet for learners) touch the ground. Raise it gradually as confidence grows. See cycle for kids.
Signs it's wrong
| Symptom | Likely cause |
|---|---|
| Knees ache at the front, pedalling feels heavy | Saddle too low |
| Hips rock, back of knee hurts | Saddle too high |
| Numb hands, sore neck | Reach too long or saddle tilted forward |
Keep the saddle level; adjust fore-aft so your knee is roughly over the pedal axle when the cranks are level.
How to measure inside leg
- Stand in socks against a wall, feet about 15 cm apart.
- Press a hardback book up between your legs, spine against the wall.
- Measure from the top of the book to the floor in cm.
Use this with the cycle size chart to choose frame size. For kids, compare inside leg with the cycle's lowest saddle height — it should be equal or slightly more.
Frame size rules of thumb
- Mountain bike frame (inches): about inside leg (cm) × 0.23.
- Hybrid/road frame (cm): about inside leg (cm) × 0.65–0.67.
These are starting points — makers' charts and a test ride are best.
Handlebar height and reach
Once the saddle is right, check the handlebar:
- Upright comfort: handlebar roughly level with the saddle or a little higher — good for city riding and beginners.
- Sporty: handlebar a few centimetres below the saddle — faster but harder on the back and hands.
- Reach: with hands on the grips, elbows should be slightly bent and shoulders relaxed.
Many cycles let you raise the handlebar by moving spacers under the stem, or by fitting a stem with more rise. On kids' cycles, the handlebar post can usually be raised as they grow.
Re-check as you go
Saddles slip and children grow. Check saddle height every few weeks for kids and after any adjustment or transport for adults. Mark the correct height on the seat post with a small piece of tape so you can reset it quickly.
Frequently asked questions
How do I set cycle seat height?
Sit on the saddle, put your heel on the pedal at its lowest point and adjust until your leg is straight. Pedalling normally, your knee will then be slightly bent.
How do I measure inside leg for a cycle?
Stand in socks against a wall with feet about 15 cm apart, put a hardback book between your legs pressed up gently, and measure from the top of the book to the floor.
Should my feet touch the ground on a cycle?
Children and beginners should be able to touch the ground. Experienced adults with a correctly set saddle usually only reach the ground on tip-toe or by leaning the cycle.
What happens if the saddle is too low?
Your knees bend too much, pedalling feels hard and knees can ache at the front. If it's too high, your hips rock and the back of your knees can hurt.
Tell us the rider's height, age and budget — we'll recommend a bike, whether or not we stock it.